The laser dust collector in stock flight removal mechanism uses electric motor to drive the bias pain wheel, and the connecting rod makes the cloth bag vibrate and removes the dust on the surface of the filter bag. Its control installation is divided into two kinds: automatic control and manual control. Automatic control means that when the fan continues the task, the single-machine bag dust collector flying mechanism actively vibrates dust on time, the manual fan dust collector stops the active task of the flying mechanism, the active stop after tens of seconds, can also start the dust cleaning motor at any time according to the demand, the cleaning time is adjusted by the user time relay. Structure performance features: single machine dust collector, dust catcher is a small volume, dust removal of air purification equipment. Suitable for all kinds of vertical dust production points, flexible and convenient, local dust collection, local treatment, can be clean air. The basic structure is composed of dust removal box, centrifugal fan, filter bag (filter cylinder), dust collector and microcomputer controller, etc. The dust is sucked into the dust collector box by the negative pressure of the fan through the suction pipe, and the coarse dust is initially filtered by the filter and directly drops to the dust collector by gravity. The fine dust is captured by the filter on the outer surface. The clean gas flows into the clean room after filtration, decomposition and purification through the filter element, and is discharged from the outlet by the fan.

What knowledge should we know about the downtime maintenance of laser dust collector in stock? The following, for you to talk about in detail:

1. Check and maintain the laser dust collector in stock and dust removal system after shutdown.

2. Open the box and the manhole door at the top of the laser dust collector in stock for ventilation and cooling, and replace the gas in the box. When the temperature and gas concentration in the tank drop to the appropriate level, personnel can enter. If the personnel need to enter the middle box, the ash bucket is emptied.

Three, check the filter bag, if found damaged should be replaced in time. , when the filter bag has reached the design life, it is advisable to replace all the filter bags.

Iv. Check the spray device in stock of laser dust collector, and it is found that the dislocation, loosening and falling off of the spray pipe should be dealt with in time.

5. Check the ash accumulation, scaling and wear at the valve and bypass valve of the laser dust collector in stock, and deal with the problems in time. After processing, first manually open and close the valve, observe the flexibility and tightness of the valve, the action should not be less than 3 times. Then the automatic operation of the valve, check the flexibility and tightness of the valve, the action should not be less than 3 times.

Vi. Check the ash accumulation on the surface of laser dust collector in stock filter bag. Check the inner wall of the ash hopper for ash accumulation and scaling. Check the air distribution plate for wear and scaling.

Seven. Check the air filter of the air compressor (Roots fan), and replace or deal with the blockage in time.

8. Check the oil level and oil quantity of mechanical and electrical equipment. If it does not meet the requirements, it should be supplemented and replaced in time.

Nine, check the spray cooling system nozzle wear and blockage, and test spray, test spray should not be less than 2 times. If the nozzle is seriously worn, it should be replaced.

Ten, check the primary components and pressure measuring pipe and scaling, wear and plugging condition, find problems timely treatment.

11. After the above work is completed, confirm that there is nothing inside the laser dust collector in stock, and close all the inspection doors (holes) of the dust collector. Ensure that inlet and outlet valves are open, bypass valves are closed, and actuator is in automatic position. Maintain laser dust collector in stock.

laser dust collector in stock https://www.kaisenfilter.com/KSDC-6102-Laser-Dust-Collector.html